The processes we actually run, and the ones we do not

Process scope is confirmed during technical review for each assembly. The list below describes the process families we work with; it is not a claim of capability for every combination within them.

Process families

  • Wire preparation — cutting, stripping and tinning to length and tolerance.
  • Termination — crimping, soldering and resistance welding.
  • Shielding and grounding — braid termination, drain wire and ground continuity.
  • Overmolding and strain relief — molded transitions and booted connectors.
  • Assembly — multi-branch builds, splices, labeling and bundling.
  • Testing — electrical and mechanical checks per the inspection plan.

Outside our current scope

Being explicit about boundaries saves both sides a review cycle. The following are not offered today:

  • Cleanroom molding and cleanroom assembly.
  • In-house sterilization or sterilization validation.
  • Clinical or biocompatibility testing and the associated regulatory submissions.

Equipment and capacity

A detailed equipment list, capacity figures and facility photographs are available on request or during a supplier audit. We do not publish production figures on this website because they change, and a stale number is worse than none.

Change control

Any change to material, process or supplier that could affect form, fit or function is raised with you before it is implemented. The change record is filed against the part number.

Start a project

Send us a drawing, or a question.

Tell us what the assembly has to do. An engineer reads every inquiry before a price is given.

Start your project